| Last Modified: 11-29-2007 | 1.6 D | |
| Service Category: Vehicle Interior | Section: Heating/Air Conditioning | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001FMN00KX |
| Title: HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM: CHECK MODE PROCEDURE (2008 Sequoia) | ||
CHECK MODE PROCEDURE
1. PANEL DIAGNOSIS (INDICATOR CHECK)
(a) Turn the ignition switch off.
|
(b) Press and hold the A/C control AUTO switch and Recirculation/Fresh switch simultaneously, and turn the ignition switch to ON. Continue holding the 2 switches until the panel diagnosis mode begins. |
(c) Check that all indicators and the display area are turned on and off 4 times in succession at 1 second intervals.
HINT:
After the indicator check is completed, the system automatically enters sensor check mode.
(d) Press the OFF switch to terminate the panel diagnosis.
2. PANEL DIAGNOSIS (SENSOR CHECK)
(a) Perform the indicator check.
HINT:
After the indicator check is completed, the system automatically enters sensor check mode.
(b) Press the REC/FRS switch to enter actuator check mode.
(c) After the actuator check is completed, press the AUTO switch to enter sensor check mode.
NOTICE:
The sensor check must be performed again after the actuator check is completed because sensor check mode, which starts automatically after the indicator check, cannot fully detect malfunctions.
|
(d) Check the sensor check results displayed on the set temperature display.
HINT:
|
(e) When any sensor check codes are displayed, refer to the DTC Chart
.
(f) Press the OFF switch to terminate the panel diagnosis.
HINT:
Pressing the REC/FRS switch returns the system to actuator check mode.
3. PANEL DIAGNOSIS (CLEAR SENSOR CHECK CODE)
(a) Inspect and repair or replace the malfunctioning parts.
|
(b) Clear the sensor check codes. (1) While pressing the Fr DEF switch during sensor check mode, press the Rr DEF switch. HINT:
Sensor check codes can be cleared by removing the A/C fuse from the main body ECU for more than 60 seconds. |
(c) Perform the sensor check and confirm that normal code 00 is displayed.
|
|
4. PANEL DIAGNOSIS (ACTUATOR CHECK) (a) Start the engine and warm it up. (b) Perform the indicator check. (c) When the sensor check is started after the indicator check, press the REC/FRS switch to start the actuator check. HINT:
Perform the actuator check with the engine running. (d) Check the temperature and blower levels by hand at each step while the actuator check proceeds from step 0 to 9 at 1 second intervals (continuous operation). HINT:
Each step number is displayed on the set temperature display. (e) To display step numbers one by one manually, press the Fr DEF switch to activate the step operation. The step number changes each time the Fr DEF switch is pressed. HINT:
(f) Press the OFF switch to terminate the panel diagnosis. HINT:
Pressing the AUTO switch returns to sensor check mode.
|
|
|